Pneumatics, Compressors, Dryers, Tanks, Pneumatic installations, Air prepration units, Gauges, Pneumatic tubes, Pneumatic valves, Pneumatic cylinders, Pneumatic fittings.

Screw compressors Series K

Series KA 2,2 - 7,5 kW

Series KBV 15 - 22 kW

Series KSA 11 kW

Series KSB 15 - 22 kW

Series KSA 30 - 90 kW

Series KS 97 kW

Series KSV 11 - 90 kW

The screw compressor - the compression in the compressors of this type is done by the overlap of two rotors of the cut line of the worm (screw). Line one rotor (the 'male', also called primary or active) enters into the profile - the second recess ('female', also called passive). The two rotors rotate in opposite directions. The oil-lubricated compressor impeller main rotor passive. The advantages of helical modules is their high strength and efficiency.
Typical pressure generated by the screw compressors 8 - 13 bar. This pressure is most commonly used in industry.

Screw compressors are designed for continuous operation (24h ) and therefore can be used in large enterprises operating in such a system. With this type of compressors compressor configuration is possible, ie .:

• screw compressor itself,
• screw compressor with dryer
• screw compressor on the tank
• screw compressor on the tank with refrigerant dryer

The characteristic of this type of screw compressors is very quiet 61-69 db , which is different than reciprocating compressors. Screw compressors have the ability to adjust easily to the settings of the operating parameters via the control panel.

Selection of the appropriate screw compressor obviously depends on the type and amount of the load. It is important to choose appropriate compressed air tank, which will be the optimal for storage of the compressed air.